I have been, since I got the program, drawing out my frames by hand and scanning them in as drawings. I noticed that only the darkest line appeared when I drew in pencil and when I started using Sharpie and it got a little better. Unfortunately this didn’t give me very good control over the image because the marker would bleed. Then I found that those black gel pens work a lot better, but, I was wondering if anyone else knew of a better way to get the lines to appear in the drawings. Or, even better, if there’s some overly simple way to get the pencil drawings to scan in clearly. Figured I’d ask because I just don’t have the patience with these machines to experiment and figure it out for myswelf.
Check out “Importing Bitmap scanned images to TB 4.0”:
Thanks. This will save me some time.